Removing The Floppy Drive - HP Vizualize,Visualize b2000 Supplementary Manual

Unix workstations
Hide thumbs Also See for Vizualize,Visualize b2000:
Table of Contents

Advertisement

9. Verify that the floppy data and power cables are positioned so they come out of the top edge of
the floppy disk drive bay's EMI shield. This edge is rounded to prevent cutting of the cables. See
Figure 2-32
. Next, secure the floppy disk drive bay's EMI shield using the T-15 Torx/slotted
screw. When you replace the EMI shield, the ferrite bead on the data cable must remain inside of
the floppy disk drive bay's EMI shield.
Figure 2-32
Replacing the Floppy Disk Drive Bay's EMI Shield
10.Remove the plastic floppy disk drive blank from the workstation's front bezel.
11.Complete the installation of the floppy disk drive by replacing the front and side panels
of the workstation as explained in the sections "Closing the Left Side Panel" and
"Closing the Front Bezel" in this chapter. You should also make sure that all cables are
neatly folded or positioned within the workstation. This will prevent potential damage
to the cables.
12.Verify that the floppy disk drive is recognized by the system. See "Verifying the Floppy
Drive Configuration" on page 44.

Removing the Floppy Drive

1. Remove the two T-15 Torx screws that secure the floppy drive tray to the front of the
chassis.
Chapter 2
Power Cable
EMI Shield
Data Cable
Parts Replacement Procedures
Floppy Drive
T-15
Torx/Slotted
Screw
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Visualize b2000C3700 - workstation

Table of Contents