Closing The Front Bezel; Left Side Panel - HP Vizualize,Visualize b2000 Supplementary Manual

Parts Replacement Procedures
Front Bezel and Left Side Panel

Closing the Front Bezel

Perform the following steps to close the workstation.
1. Locate the hinges on the left side of the front bezel, and insert them into the holes
located along the left edge of the workstation.
2. Rotate the front bezel inward until you hear the two latch buttons snap in place. The
front bezel is now closed.
3. Plug in the workstation's power cord, and power on the workstation.

Left Side Panel

This section explains how to open and close the left side panel of the workstation. This side
panel will have to be opened whenever you need access to the internal components of the
workstation.
Opening the Left Side Panel
Perform these steps to open the left side panel.
WARNING Always unplug the workstation's power cord from the electrical
outlet or power source before opening the workstation. Reference
"Safely Powering Down the B2000 Workstation" on page 12.
1. Power off the workstation, and unplug the workstation's power cord from the electrical
outlet.
2. Attach the static-grounding wrist strap by following the instructions on the package.
Attach the sticky end of the wrist strap to bare metal on the back panel of the
workstation. See Figure 1-1. on page 10.
3. Turn the workstation around so its back is facing you. Remove the two T-15 Torx
thumbscrews as shown in Figure 2-2.
16 Chapter 2