CD Drive
This section explains how to remove and replace the CD drive.
Removing a CD Drive
This section explains how to remove a CD drive from your workstation.
WARNING
Turn the workstation off and unplug the power cord before
removing the CD drive.
CD drives are susceptible to mechanical and electronic shock. When handling
CAUTION
the drive, always wear the static-grounding wrist strap that came in the CD
drive kit. Always handle the drive carefully.
1. Perform the procedures in the sections "Opening the Front Bezel" and "Opening the
Left Side Panel." The front bezel needs to be opened so you can remove the CD drive
from the workstation chassis. The left side panel needs to be opened so you can get to
the CD drive's audio, ATAPI and power connectors.
2. Remove the CD drive bay's EMI shield by unscrewing the T-15 Torx/slotted screw as shown in
Figure 2-16
. Note that the CD drive bay's EMI shield is located on the back of the removable
media chassis inside the workstation. Push the cover handle away from the back of the
removable media chassis approximately one inch. Next pull the cover handle toward you. The
audio, ATAPI and power cables are now accessible to you. Disconnect these cables from the CD
drive.
Chapter 2
Parts Replacement Procedures
CD Drive
29