HP Vizualize,Visualize b2000 Supplementary Manual page 19

NOTE Reference the B2000 system label for the correct memory loading sequence.
2. Position the memory slots so they face you as shown in
provides the loading sequence for the DIMM cards. This loading sequence must be maintained
when you install the DIMM cards, but the size of the DIMM card put in each slot can vary. For
example, you can install a 256Mbyte card before a 512Mbyte card and then follow the
installation of the 512Mbyte card with another 256Mbyte card. The B2000 workstations
supports 128 Mbyte, 256 Mbyte and 512 Mbyte DIMM cards.
3. Locate the four internal memory slots, and load the DIMM cards in the slots using the
loading sequence provided in Figure 2-4. Note that the label located on the floor of the
chassis describes the installation sequence.
Figure 2-4 Memory Card Slot Numbers and Loading Sequence
SL0
SL3
SL1
SL2
Chapter 2
Load 1st
Load 4th
Load 2nd
Load 3rd
Parts Replacement Procedures
Figure 2-4
. Note that
Memory DIMMs
Figure 2-4
also
Memory Slots
(four slots)
19