HP Vizualize,Visualize b2000 Supplementary Manual page 34

Parts Replacement Procedures
CD Drive
5. Remove the CD drive from its shipping container and verify that the jumper on the back of the
CD drive is set to the C Select position. Using the four blank filler screws (T-15 Torx/slotted
screws) that were just removed, mount the disk drive to the bracket as shown in
Note that the CD drive should extend approximately one inch out from the front of the CD drive
bracket.
Figure 2-22. Installing the CD Drive
6. Slide the CD drive and its bracket into the workstation chassis as shown in Figure 2-22.
There are runners on the side of each bracket and guides inside the CD drive chassis
that will help the assembly to slide into place.
34
Blank Filler Screws
Figure 2-22.
CD Drive Bracket Guide
CD Drive
Bracket Screws
Chapter 2