Installing The System Fan Assembly - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual
Hp z200 sff workstation maintenance and service guide
Hide thumbs
Also See for Z200 - Small Form Factor Workstation:
- Maintenance and service manual (210 pages) ,
- User manual (87 pages) ,
- Overview (54 pages)
Table of Contents
Advertisement
6.
Disconnect the system fan assembly cable from the system board as shown in the following figure.
Figure 5-42
7.
Remove the fan assembly by pushing in on the four release tabs on the front of the chassis (1),
and then sliding the fan assembly into the chassis until you can lift it out.
Figure 5-43
Installing the system fan assembly
To install the system fan assembly, reverse the removal steps.
104 Chapter 5 Replacing components
Disconnecting fan wires
Removing the fan assembly
ENWW
- Quick Links:
- System Board Architecture
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Z200 - Small Form Factor Workstation and is the answer not in the manual?