Table of Contents
Advertisement
Parts Replacement Procedures
LCD Display with Power Switch and Display Cable
Installing the LCD Display/Power Switch Assembly
For installation perform the following steps:
1. Open the front bezel as shown in the section "Opening the Front Bezel" on page 15.
2. Engage the right side of the LCD Display/Power switch assembly tab into the chassis
slot.
3. Squeeze the left side clips while rotating the assembly into the chassis position. As the
assembly is flush with the chassis, release the tab. The LCD assembly will snap into
place.
4. Plug the flat ribbon cable into the 25 pin connector on the chassis.
LCD Display/Power Switch Assembly
Figure 2-70.
5. Replace the front bezel. See "Closing the Front Bezel" on page 16.
6. Turn to Chapter 3, "Wrapping Up," on page 85 to complete the installation procedure.
78
25 Pin Connector
Chapter 2
Advertisement
Table of Contents
Need help?
Do you have a question about the Vizualize,Visualize b2000 and is the answer not in the manual?
Questions and answers