Download  Print this page

Installing The System Fan Assembly - HP Z200 Maintenance And Service Manual

Small form factor workstation.
Hide thumbs

Advertisement

6.
Disconnect the system fan assembly cable from the system board as shown in the following figure.
Figure 5-64
7.
Remove the fan assembly by pushing in on the four release tabs on the front of the chassis (1), and
then sliding the fan assembly into the chassis until you can lift it out.
Figure 5-65

Installing the system fan assembly

To install the system fan assembly, reverse the removal steps.
ENWW
Disconnecting fan wires
Removing the fan assembly
Removing and installing components
117

Advertisement

Table of Contents

   Related Manuals for HP Z200

This manual is also suitable for:

Z200

Comments to this Manuals

Symbols: 0
Latest comments: