HP Vizualize,Visualize b2000 Supplementary Manual page 58

Parts Replacement Procedures
Power Supply
2. Remove the four T-15 Torx screws from the rear of the chassis. See Figure 2-47.
Figure 2-47. Power Supply T-15 Torx Screws
3. Unplug the three power supply cables from the system board. See Figure 2-48.
Figure 2-48. Power Supply Cables
4. Detach the bundled power cables from the cable management clip on the chassis floor.
See Figure 2-48.
58
T-15 Torx Screws
T-15 Torx Screws
Power Supply
Cables (3)
Bundled Power
Cables
Chapter 2