Table of Contents
Advertisement
Parts Replacement Procedures
Fans (I/O and System Board Fan)
Installing the System Board Fan
Perform the following steps to install the system board fan:
1. While grasping the fan with one hand, align the air flow arrow to point to the rear of the
chassis. You will find the arrow molded on the edge of the fan.
2. Hold the fan flat to the rear of the chassis and align the mounting holes to the chassis.
3. Insert the flat head of the rivet(s) from the rear panel.
Figure 2-68. Placement of Rivets
Flat Head
of Rivets
4. Plug the fan cable into the system board.
5. Replace the left side panel. Refer to the section, "Left Side Panel" on page 16.
6. Follow the instructions in Chapter 3, "Wrapping Up," on page 85.
76
Flat Head
of Rivets
Chapter 2
Advertisement
Table of Contents
Need help?
Do you have a question about the Vizualize,Visualize b2000 and is the answer not in the manual?
Questions and answers