HP Vizualize,Visualize b2000 Supplementary Manual page 38

Parts Replacement Procedures
Floppy Drive
3. Rotate the workstation around until you see the front of the workstation as shown in
2-27
.
Figure 2-27 Front of Workstation with the Front Bezel Removed
4. Remove both floppy disk bracket screws (T-15 Torx/slotted screws) and pull the floppy disk
bracket out of the chassis assembly as shown in
blank filler screws (T-15 Torx/slotted screws) as shown in
from the bracket. You are now ready to mount the floppy disk drive into the floppy disk bracket.
Figure 2-28 Removing the Floppy Disk Bracket and Blank
38
Blank Filler Screws
(T-15 Torx Screws)
Blank Screw
(T-15 Torx Screw)
Figure 2-28
. Next remove the four floppy disk
Figure 2-28
Figure
Floppy Drive
Blank
and remove the blank
Bracket
T-15 Torx
Screw
Blank
Chapter 2