HP Vizualize,Visualize b2000 Supplementary Manual page 27

The steps required for removing an I/O card from the workstation are:
1. Power off the workstation, and unplug the workstation's power cord from the electrical
outlet. Note that when you press the workstation's power switch, the workstation
automatically performs a shutdown -h.
2. Open the side panel of the workstation as explained in the section "Opening the Left
Side Panel" in this chapter.
3. Pull downward in the direction of the arrow on both PULL tabs of the I/O card retainer
to remove it. See Figure 2-14.
Figure 2-14 Removing the I/O Card Retainer
4. Locate the I/O card you want to remove and using a T-15 Torx driver remove the I/O
card's bulkhead screw as shown in Figure 2-15.
Figure 2-15 Removing the I/O Card
5. Pull evenly on the outside edges of the I/O card to remove it. See Figure 2-15.
Chapter 2
I/O Card Retainer
I/O Card
Bulkhead
Torx Screw
I/O Card
Bulkhead
Parts Replacement Procedures
PCI I/O Card(s)
I/O Card
Air Divider
I/O Card Being Removed
27