Removing I/O Cards - HP Vizualize,Visualize b2000 Supplementary Manual

Parts Replacement Procedures
PCI I/O Card(s)
If you are installing an additional graphics card, you must insert the fx card
CAUTION
in Slot 1 for optimal performance.
After you connect the monitor to the additional graphics card, you will need to
change the graphics path for that monitor. To do this read the section
"Displaying and Setting the Monitor Type" in the chapter "The Boot Console
Interface" of your Owner's Guide.
The label on the chassis floor of your workstation contains important information for I/O
configuration. See Figure 2-12.
Figure 2-12. B2000 System Label
Note that the four I/O slots as seen from the back of the workstation are labeled from top
to bottom starting with one. See Figure 2-13.
Figure 2-13 I/O Slot Numbering

Removing I/O Cards

You will need a T-15 Torx driver or flathead screwdriver to remove the I/O slot bulkhead
screws.
26
I/O Slot 1
I/O Slot 4
Chapter 2