HP b2600 Install Manual

Hewlett-Packard Company
3404 East Harmony Road
Fort Collins, Colorado 80528
A785xA CD-RW Drive in B-, C- and J-Class HP-UX Workstations
For a tutorial on creating CD-RW masters on HP-UX systems, refer to the
/opt/OpenSource/cdrtools-1.10/USER_GUIDE.pdf file on the CD-RW software media.
Supported Features.
as a data storage and exchange device. Hewlett-Packard does not support the creation or duplication
of audio CDs using this product and software. It is also recommended that you DO NOT use this drive
as a backup tool.
Audio CD duplication
Create bootable HP-UX CD
Duplicate bootable CD
Multi-Session recording
Copying HP-UX install CD
Copy CD-to-CD
Disk-at-once recording
Track-at-once recording
Data recording (any file type)
Hardware Installation
The A785xA CD-RW drive you have purchased may be installed in any one of several models of HP-
UX Workstations - b1000, b2000, b2600, c3000, c3600, c3650, c3700, j5600, j6000 or j6700. For com-
plete instructions on how to install the drive on your system, please refer to the appropriate Owners
Guide, Parts Replacement Guide or Technical Reference for your system. These documents can be
found at: http://www.hp.com/workstations/support/documentation/hpux_manuals.html
This CD-RW drive can either be installed to replace an existing CD-ROM drive or as a new drive
where none existed before. It also may have been integrated into your computer at the HP factory. HP
CD-RW drives were designed to operate in the horizontal position. Do not position your workstation
so the CD-RW drive is in a vertical position.
If you are replacing an existing CD-ROM drive with the CD-RW Drive, you must load the
PHKL_24282 (for HP-UX 11.0) or PHKL_24283 (for HP-UX 11i) patches from the CD-RW software
media. If you are installing a new drive where none existed before, you must load the patches from
the http://us-support.external.hp.com web site. Make sure these patches are installed on your sys-
tem before attempting to install the hardware.
Read Before Installing
This product (and associated software) is intended to be used primarily
Feature
No (both GUI and command line)
GUI=No, Command line=Yes
Yes (GUI and command line) if CD is valid
No (both GUI and command line)
For more information go to USER_GUIDE.pdf on
the CD
No (both GUI and command line)
No (both GUI and command line)
Yes (both GUI and command line)
Yes (both GUI and command line)
HP Support
Pub. No. A7853-90010