Removing Memory Dimms - HP Vizualize,Visualize b2000 Supplementary Manual

Figure 2-6 Installing Memory Cards
5. Place the DIMM card in the connector, lining it up with the guides. Make sure you align
the notches on the bottom edge of the DIMM card with the DIMM connector keys. See
Figure 2-6.
6. Press firmly and evenly on the DIMM card to ensure that it seats properly.
NOTE The ejector tabs will return to the locked position when the DIMM card is
fully seated in the connector.
7. Replace the left side panel as explained in the section "Replacing the left side panel" in
this chapter. Plug the power cord into the electrical outlet.
8. Verify that this installation was successful by following the steps in "Displaying the
Current Memory Configuration" on page 23.

Removing Memory DIMMs

Perform the following steps to remove memory (DIMM cards) from your workstation.
WARNING Always unplug the workstation's power cord from the electrical
outlet or power source before opening the workstation. Reference
"Safely Powering Down the B2000 Workstation" on page 12.
Chapter 2
Step 1
Notches
Step 2
Black
Ejector Tab
Parts Replacement Procedures
Memory DIMMs
Press down on ejector tabs to
open them and place the
DIMM card in the connector
so that your fingers are on
the edge of the DIMM card.
Push the DIMM card down
firmly and evenly into the
connector to be sure it is
properly seated.
White
Ejector Tab
21