HP Vizualize,Visualize b2000 Supplementary Manual page 51

4. Replace the four mounting screws on the hard disk drive bracket to store them for future use.
Slide the mounting bracket into its hard drive slot, and push firmly inward to secure the hard
drive bracket to the system board connector. Tighten the T-15 Torx thumbscrew to secure the
bracket to the system board. See
explained in the section "Closing the Left Side Panel" on page 17 in this chapter.
Figure 2-45 Replacing the Hard Disk Drive Bracket
Chapter 2
Figure 2-45
. The side panel should now be replaced as
Parts Replacement Procedures
Hard Disk Drive
51