Table of Contents
Advertisement
Parts Replacement Procedures
Fans (I/O and System Board Fan)
Fans (I/O and System Board Fan)
This section explains how to remove and replace the I/O fan and the System Board Fan.
WARNING
Turn the workstation off and unplug the power cord before
installing or removing fans. Reference "Safely Powering Down the
B2000 Workstation" on page 12.
CAUTION
To prevent damage to the B2000 workstation, observe all of the ESD
precautions described in "Electrostatic Discharge (ESD) Precautions" on
page 9.
Removing the I/O Fan
To remove the I/O cooling fan, do the following:
1. Remove the workstation left side panel. See the section "Opening the Left Side Panel"
on page 16.
2. Lay the workstation on its side, and remove all of the I/O cards. See the section
"Removing I/O Cards" on page 26.
3. Remove the system unit air divider as shown in Figure 2-63. by unscrewing the two
T-15 Torx screws, which hold it in place. Next grasp the edge of the air divider and pull
it towards you.
Figure 2-63. Removing the Air Divider
T-15 Screw
4. Remove the fan and speaker cables from the system board and lift up on the bracket
mounting clip. See arrow in Figure 2-64. Next grab hold of the fan and speaker bracket
72
Air Divider
T-15 Screw
Chapter 2
Advertisement
Table of Contents
Need help?
Do you have a question about the Vizualize,Visualize b2000 and is the answer not in the manual?
Questions and answers