Rear System Fan Assembly; Removing The Rear System Fan Assembly; Installing The Rear System Fan Assembly - HP Z210 Maintenance And Service Manual

Rear system fan assembly

This section describes how to remove and install the rear system fan assembly.

Removing the rear system fan assembly

To remove the rear system fan assembly:
1. Disconnect power from the workstation (see
2.
Remove the side access panel (see
3. Disconnect the rear system fan assembly cable (1) from the system board as shown in the
following figure.
Figure 5-23
4.
Remove the four screws from the rear of the chassis (2), and then pull the fan assembly inward
and then up (3) out of the chassis.

Installing the rear system fan assembly

To install the rear system fan assembly, reverse these steps.
82 Chapter 5 Replacing components
Removing the side access panel on page
Disconnecting fan wires
Predisassembly procedures on page 62).
65).
ENWW