Voltage Regulator Modules (VRMs)
This section explains how to remove and replace the voltage regulator modules (VRMs).
WARNING
Turn the workstation off and unplug the power cord before
removing or installing voltage regulator modules. Reference "Safely
Powering Down the B2000 Workstation" on page 12.
CAUTION
To prevent damage to the VRMs, observe all of the ESD precautions as
described in the "Electrostatic Discharge (ESD) Precautions" on page 9.
VRMs are installed on the system board in pairs. The top VRM is a master and the bottom
VRM is the slave.
Figure 2-53. VRMs on the System Board
Removing VRMs
To replace defective VRMs follow the steps below:
1. Remove the left side panel. See "Opening the Left Side Panel" on page 16.
Chapter 2
Parts Replacement Procedures
Voltage Regulator Modules (VRMs)
VRM Master
VRM Slave
63