Figure 4-12. Removing The Floppy Disk Drive Bay's Rear Cover - HP Vizualize,Visualize b2000 Supplementary Manual

Field Replaceable Units
FRU Removal and Replacement
Removing a Floppy Disk Drive
WARNING Power off the workstation and unplug the power cord before
removing the floppy disk drive.
CAUTION Floppy disk drives are susceptible to mechanical and electrostatic shock.
When handling the drive, always wear the static-grounding wrist strap that
came in the floppy disk drive kit. Always handle the drive carefully.
Perform the following steps to remove a floppy disk drive:
1. Open the front and left side panels of the workstation as shown in the sections
"Opening the Front Panel" and "Opening the Left Side Panel."
2. Remove the rear cover of the floppy disk drive bay inside the workstation by unscrewing
the T-15 Torx/slotted screw as shown in Figure 4-12. Push the cover handle toward the
rear of the floppy disk drive approximately one inch, and then pull the cover handle
toward you.

Figure 4-12. Removing the Floppy Disk Drive Bay's Rear Cover

Rear Cover Handle
Power Cable
Rear Cover
3. Disconnect the power and data cables from the rear of the floppy disk drive.
4. Rotate the workstation around until you can see the front of the workstation as shown
in Figure 4-13.
96
Data Cable
T-15
Torx/Slotted
Screw
Chapter 4