Removing The Floppy Drive Tray Assembly - HP Digital AlphaStation 255 Family User Information

Installing System Options

Removing the Floppy Drive Tray Assembly

If you need further access to the memory SIMMs, you can temporarily remove the floppy
drive tray assembly. To remove the floppy drive tray assembly from the system unit, see
Figure 4–4 and follow this procedure:
1. Turn off your system and unplug the power cord from the wall outlet.
2. Unlock and remove the top cover panel, as described earlier in this chapter.
3. Squeeze the tabs
the enclosure. Slide the drive assembly toward the rear of the system unit and lift and
remove it.
4. Remove the data and power cables from the floppy drive assembly. Note the position
of the cables so that you can reconnect them later.
Figure 4–4: Removing Floppy Drive Tray Assembly
4–6
Q
on both sides of the rear of the floppy drive tray to release it from
1