Table of Contents
Advertisement
Goodrive100-PV Series Solar Pump Inverter
cannot be greater than 440V. For -45 models equipped with the boost module, the DC
input voltage cannot be greater than 600V.
C.3 Wiring description
The following figures show the wiring terminals of IP54 inverters.
Figure C–5 Wiring terminals of -4 models for inverters ≤ 2.2kW
Figure C–6 Wiring terminals of -S2/-SS2 models for inverters ≤ 2.2kW
Terminal function description:
Symbol
R, S, T
N
+
-
R
Figure C–4 Wiring terminals of 4-37kW models
+
-
+
-
Terminal
name
3PH 380V/220V AC input terminals, connected to the grid
Neutral wire.
AC input
For inverter models of 4-37kW, it is required to use
three-phase four-wire distribution system and connect the
neutral wire to terminal N.
Power frequency & PV switching solution
S
T
N
R
S
T
L
N
-71-
U
V
W
U
V
W
U
V
W
Description
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Goodrive100-PV Series and is the answer not in the manual?
Questions and answers
I want to connect a low water level sensor to GD100-PV invt how it supposed to do
The low water level sensor should be connected to the INVT Goodrive100-PV Series inverter at the designated terminal. Based on the standard wiring diagram:
1. Identify the low water level switch terminals.
2. Connect the common terminal of the sensor to the COM terminal on the inverter.
3. Connect the sensor output to the appropriate input terminal (e.g., S1 or S4) on the inverter.
4. Ensure wiring is secure and correctly configured according to the installation guidelines.
This setup allows the inverter to receive signals from the low water level sensor and respond accordingly.
This answer is automatically generated
@Hamse Ismael