Table of Contents
Advertisement
Goodrive100-PV Series Solar Pump Inverter
Function
code
V/F frequency
P04.03
point 1 of motor
V/F voltage
P04.04
point 1 of motor
V/F frequency
P04.05
point 2 of motor
Name
larger torque boost, however, if the torque
boost is too large, the motor will run at
over-excitation, which may cause increased
output current and motor overheating, thus
decreasing the efficiency.
When torque boost is set to 0.0%, the
inverter uses automatic torque boost.
Torque boost cut-off threshold: Below this
frequency threshold, torque boost is valid;
exceeding this threshold will invalidate
torque boost.
Setting range of P04.01: 0.0%: (automatic)
0.1%–10.0%
Setting range of P04.02: 0.0%–50.0%
If
P04.00
P04.03–P04.08.
V/F is set to the motor load.
1
Note: V1＜V2＜V3; f1＜f2＜f3. If the
low-frequency voltage is high,
overtemperature and burning may occur and
the overcurrent stall and protection may
occur to the inverter.
1
100.0%
1
Description
Output voltage
b
boost
Cut-off
=1, the user can set V//F curve by
Output voltage
b
V3
V2
V1
f1
f2 f3
-29-
Function parameter list
Default Modify
Output
frequency
0.00Hz
00.0%
00.00
Output
frequency
(Hz)
f
b
○
○
○
Hz
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Goodrive100-PV Series and is the answer not in the manual?
Questions and answers
I want to connect a low water level sensor to GD100-PV invt how it supposed to do
The low water level sensor should be connected to the INVT Goodrive100-PV Series inverter at the designated terminal. Based on the standard wiring diagram:
1. Identify the low water level switch terminals.
2. Connect the common terminal of the sensor to the COM terminal on the inverter.
3. Connect the sensor output to the appropriate input terminal (e.g., S1 or S4) on the inverter.
4. Ensure wiring is secure and correctly configured according to the installation guidelines.
This setup allows the inverter to receive signals from the low water level sensor and respond accordingly.
This answer is automatically generated
@Hamse Ismael