Table of Contents
Advertisement
Goodrive100-PV Series Solar Pump Inverter
Function
code
V/F voltage
P04.06
point 2 of motor
V/F frequency
P04.07
point 3 of motor
V/F voltage
P04.08
point 3 of motor
V/F slip
P04.09
compensation
Two phase
control
P04.34
selection of
single-phase
Voltage ratio of
P04.35
V-phase and
U-phase
Name
Setting range of P04.03:
Setting range of P04.04: 0.0%–110.0%
(rated voltage of motor1)
1
Setting range of P04.05:
Setting range of P04.06: 0.0%–110.0%
(rated voltage of motor1)
Setting range of P04.07:
(rated frequency of motor1) or P04.05–
1
P02.16 (rated frequency of motor1)
Setting range of P04.08: 0.0%–110.0%
(rated voltage of motor1)
1
Used to compensate for the motor rotating
speed change caused by load change in the
space voltage vector mode, and thus
improve the rigidity of the mechanical
characteristics of the motor. You need to
calculate the rated slip frequency of the
motor as follows:
△ f=f
-n*p/60
b
Of which, f
gain
motor, corresponding to function code
P02.01. n is the rated rotating speed of the
motor, corresponding to function code
P02.02. p is the number of pole pairs of the
motor. 100.0% corresponds to the rated slip
frequency △f of the motor.
Setting range: 0.0–200.0%
Ones: Reserved
Tens: Reversal of the secondary winding
(V-phase) voltage
0: Not reversed; 1: Reversed
motor
Setting range: 0–0x11
0.00–2.00
Description
0.00Hz–P04.05
P04.03–P04.07
P04.05–P02.02
is the rated frequency of the
b
-30-
Function parameter list
Default Modify
○
00.0%
00.00
○
Hz
○
00.0%
○
0.0%
◎
0x00
○
1.40
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Goodrive100-PV Series and is the answer not in the manual?
Questions and answers
I want to connect a low water level sensor to GD100-PV invt how it supposed to do
The low water level sensor should be connected to the INVT Goodrive100-PV Series inverter at the designated terminal. Based on the standard wiring diagram:
1. Identify the low water level switch terminals.
2. Connect the common terminal of the sensor to the COM terminal on the inverter.
3. Connect the sensor output to the appropriate input terminal (e.g., S1 or S4) on the inverter.
4. Ensure wiring is secure and correctly configured according to the installation guidelines.
This setup allows the inverter to receive signals from the low water level sensor and respond accordingly.
This answer is automatically generated
@Hamse Ismael