Table of Contents
Advertisement
Goodrive100-PV Series Solar Pump Inverter
4.1 Keypad introduction
The keypad is used to control the inverter, read inverter status, and set parameters. If you
need to install the keypad on another position rather than on the inverter, use a keypad
extension cable with a standard RJ45 crystal head.
Note: The inverter models of ≤ 2.2kW support an optional extermal keypad, and the keypad of
inverter models of ≥ 4kW can be installed on another device.
No.
Item
Status
1
indicator
4 Keypad operation guidelines
Figure 4–1 Keypad diagram for inverters of ≤ 2.2kW
RUN/TUNE
3
PRG
ESC
QUICK
JOG
Figure 4–2 Keypad diagram for inverters of ≥ 4kW
RUN/TUNE
FWD/REV
LOCAL/REMOT
TRIP
1
HZ
RPM
A
%
V
2
DATA
SHIFT
STOP
4
RUN
RST
Description
Inverter running status indicator.
Off: The inverter is stopped.
-15-
Keypad operation guidelines
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Goodrive100-PV Series and is the answer not in the manual?
Questions and answers
I want to connect a low water level sensor to GD100-PV invt how it supposed to do
The low water level sensor should be connected to the INVT Goodrive100-PV Series inverter at the designated terminal. Based on the standard wiring diagram:
1. Identify the low water level switch terminals.
2. Connect the common terminal of the sensor to the COM terminal on the inverter.
3. Connect the sensor output to the appropriate input terminal (e.g., S1 or S4) on the inverter.
4. Ensure wiring is secure and correctly configured according to the installation guidelines.
This setup allows the inverter to receive signals from the low water level sensor and respond accordingly.
This answer is automatically generated
@Hamse Ismael