Force Service Selection; Set Emergency Channel; Set Relays; Set Default Language - TANDBERG Alteia Instruction Manual

D.2.6

Force Service Selection

Forces the Receiver to decode a different service or stored channel (which
may require a retune). The command is generally used to hop between
services. The Director system has to be informed of the frequency,
FEC-rate and symbol-rate for each stream. This is set up using the MCC or
MEM. (The Director User Interface and the Director core require restarting
to register changes that have been set in the MCC or MEM.)
D.2.7

Set Emergency Channel

Sets the service to use in the event of a selection failure. Is activated after
a specified time has elapsed. If not set, the Power-up Channel is assumed.
Setting the Emergency Channel allows a failure situation to be recovered.
D.2.8

Set Relays

Switches the general-purpose relays. This command does not affect the
summary alarm relay.
D.2.9

Set Default Language

Sets an audio decoding preference for Audio 1 and Audio 2 when selecting
a service. The Alteia supports a number of default languages, please refer
to the manual. If the command does not contain a language on the
supported list, it is ignored.

D.2.10 Local Lockout

Locks out the LOCAL CONTROL mode but status information can still be
viewed. All Director commands are functional. The Receiver can be
unlocked locally using a PIN number or over-air using Allow Local Access.

D.2.11 Abort NCP Command

Aborts commands that have been sent but not executed. Fingerprinting
and Enable/Disable Product cannot be aborted. If a command is received
which has an expired execute time, it is acted on immediately.
D.2.12 Fingerprinting Overt/Covert and Enable/Disable
Product
The Receiver fully supports this function.
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
Using the Alteia [plus] with the Director System
Page D-5