TANDBERG Alteia Instruction Manual page 81

5.1 ASI Output Module (M2/PRO/ASI)
5.1.1 General Description
Output formats are DVB asynchronous serial (copper), and asynchronous
serial (optical). The synchronous parallel interface (TSO-SPI) is available
on the rear panel as standard. The full multiplex of compressed services
can be used for satellite signal re-distribution (via a Modulator) or for
redistribution via telecom links (using a suitable interface).
5.1.2 Connector Details
DVB ASI Copper Connector
This provides a copper connector for the DVB Asynchronous
Serial Interface (ASI) with the following consideration:
·
All models except M2/PDU/942C Decoder.
The ASI output is byte-mode only.
·
M2/PDU/942C Decoder.
If the ASI output option card is used, the output mode depends on the
input mode. If the input mode is SPI, the ASI output is byte-mode. If
the input is ASI, the ASI output is single packet burst mode.
NOTE...
Terminate this connector in 75 W when not in use.
Table 5.1: DVB ASI Copper Output
Item
Safety status
Connector type
Connector designation
Cable specification
Connection
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
Specification
SELV
BNC, Female 75 W
TSO ASI
Capable of transmitting a maximum frequency of 850 MHz
Pin: Signal Shield: Ground/Chassis
Options
Page 5-3