TANDBERG Alteia Instruction Manual page 158

Menus
C.13.5 Menu #10 (BISS)
If BISS is enabled, the following pages are displayed in menu #10.
Table C.33: Additional BISS Menu Pages Associated with Menu #10
Page Display
14 #10 CA
selectable BISS MODE
MODE 1 XXXXXXXXXXXX
#10 CA
BISS - - E ACTIVE ID
15
USER 1 XXXXXXXXXXXXXX
selectable
C.14 Data Menu (#11)
Table C.34: Data Menu (#11) Pages
Page Display
1 #11 DATA
ASYNC
OK
2 #11 DATA
SYNC
OK
3 #11 DATA
TSO
selectable
ENCRYPTED
In the M2/PTR/942 receiver, the Encrypt mode (Menu #11, page 3) should always be used.
Page C-34
Description
314/15
Please refer to TANDBERG Television Customer Services
SW regarding the use of BISS equipment.
315/15
Please refer to TANDBERG Television Customer Services
regarding the use of BISS equipment.
Description
1/44 This page displays the status and baud-rate of the asynchronous data module (supported
BITRATE after v2.1).
9600 BAUD
·
If the module is running, the page displays the legend OK and shows the current
baud-rate.
·
If the module is not running, the page displays the legend FAIL and the BITRATE is
shown as - - - - -.
32/44
This page displays the status and baud-rate of the synchronous data module. Only available
BITRATE on models with suffix B only (e.g. M2/PSR/942B).
64 KBITS/S
·
If the module is running, the page displays the legend OK and shows the current bit-rate.
·
If the module is not running, the page displays the legend FAIL and the BITRATE is
shown as - - - - -.
33/44
This CA dependent page allows selection of the route the transport stream takes within the
unit.
·
ENCRYPTED: Select encrypted if the transport stream is to pass to the TSO without
going through the CA module. Depending on the CA system used, the data will be either
partially or fully decrypted. See CAUTION following this table.
Software version 2.1.1 or earlier.
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
CAUTION...
ST.TM.E9200.8