Digital Audio Outputs - TANDBERG Alteia Instruction Manual

Installing the Equipment

Digital Audio Outputs

Table 2.18 applies to M2/Pxx/942[A][B][C][D] Models only.
Two XLR male connectors provide two stereo
channels. The output can be formatted according to
the received service and unit configuration.
Audio control is through the Audio menu #8. The
specification for this connector is given in Table B.29.
Table 2.18: Digital Audio Output Connector (XLR)
Item
Connector type
Connector designation
Pin Connections
Nominal output impedance
Load impedance
Units with Digital Audio outputs are also capable of providing Analogue
Audio. The connectors are arranged as shown in Figure 2.9. Choice of
output is made using the Audio Menus (#8).
Figure 2.9: Arrangement of Digital and Analogue Audio Connectors
NOTE...
When the digital output is used, the corresponding Audio-left connector is unused.
Further information regarding the AES/EBU digital outputs can be found in
Table B-29 and Table C-19.
Page 2-20
Specification
XLR, Male
AUDIO #1 RIGHT/AES/EBU
AUDIO #2 RIGHT/AES/EBU
Pin 1 Xternal of cable (shield/ground)
Pin 2 Live (Hot/+ve phase)
Pin 3 Return (Cold/-ve phase)
50 W
110 W balanced
Analogue Stereo 1
6447448
14243
Digital Stereo 1
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
Analogue Stereo 2
6447448
14243
Digital Stereo 2
1 2
3
AUDIO #1(2)
RIGHT/AES/EBU
ST.TM.E9200.8