TANDBERG Alteia Instruction Manual page 159

C.15 Timers Menu (#12)
This set of pages allow the current time and date to be set. It also allows a
time to be allocated to the operation of an auxiliary relay or to reconfigure
the unit to a specified preset.
NOTE...
The time is also set from a valid incoming transport stream.
Table C.35: Timers Menu (#12) Pages
Page Display
1 #12 TIMERS
TIME
13:30
2 #12 TIMERS
selectable TIME ZONE
GMT+00:00
C.16 System Menu (#13)
C.16.1 Introduction
The set of pages shown in Table C.36 is modified if the Director system is
installed and the unit is in LOCAL LOCKOUT.
Versions 2.2 and later have 21 pages (pages 12 and 13 removed)
Table C.36: System Menu (#13) Pages
Page Display
1 #13 SYSTEM
selectable CONTROL MODE
LOCAL ONLY
2 #13 SYSTEM
editable SET PIN
T T T T
3 #13 SYSTEM
editable REMOTE ADDRESS
341
4 #13 SYSTEM
selectable REMOTE INTERFACE
RS232
5 #13 SYSTEM
LCD CONTRAST
selectable
-
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
Description
1/24 This page displays the current time and date being used by the Alteia.
DATE
·
If the unit is locked to a stream, this is locked to time information contained in the stream.
11 Jun 2000
·
If the lock is lost, the unit attempts to keep the time locally until lock is reacquired.
·
If the unit has not locked to a valid stream since power up, the time and date fields are set
to -----------
32/2 This page allows the entry of local time information. 00.00 (default) local offset. The time can
be altered in increments of 30 minutes.
Description
1/234 This page allows the operating mode of the Alteia to be selected.
·
The unit can be in either LOCAL ONLY (front panel) or REMOTE ONLY.
·
If the receiver is part of an Director Systems, the receiver can also be in OVER-AIR or
LOCAL LOCKOUT mode.
32/234
Director only: Changing the PIN is accomplished by entering the current PIN number then
pressing the SAVE button. This displays the page shown. Page 2 allows the new PIN to be set
and the setting confirmed. This is used to set a new PIN to override the LOCAL LOCKOUT
state.
This page is displayed as a confirmation for the setting.
33/234
Sets the Remote Control address of the unit.
34/234 Switches the Remote Interface between RS-232 (default) and RS-485.
35/234
Allows the LCD display contrast to be set.
T +
Menus
Options
3 LSDs of serial
number (default)
Page C-35