Clearing A Preset Service; Frame Synchronisation; Frame Sync Option; Reference Signal - TANDBERG Alteia Instruction Manual

Operating the Equipment Locally

Clearing a Preset Service

To clear a preset Service from the list, follow the steps in Table 3.18.
nn is the storage slot
EDIT
Figure 3.5: Clear a Preset Service
Table 3.18: Clearing a Preset Service
Step
1.
2.
3.
4.
3.5.3

Frame Synchronisation

Frame Sync Option

For Frame Synchronisation to work, the Frame Sync option
(M2/PRO/SYNC) must have been purchased and installed in the unit. This
being the case, the Alteia plus software will detect it during initialisation
and show the corresponding menu screen (menu #6 (Video) page 13).

Reference Signal

The line standard of the Frame Sync reference signal must match the line
standard of the video signal being decoded. For a video signal line
standard of 625/50, the reference signal line standard must be 625/50 and
likewise, for a video signal line standard of 525/60, the reference signal
line standard must be 525/60.

Enabling Frame Sync

To enable Frame Synchronisation, go to menu #6 (Video), page13 (Frame
Sync). Press EDIT, rotate the SELECT knob until ENABLED is seen on the
bottom line of the display and then press SAVE.
With Frame Sync enabled, the display will show the lock status. If the
locking signal applied to the Frame Sync input is good, the display will
show LOCKED otherwise the display will show NOT LOCKED.
Page 3-18
MENU
#2 PRESET
CLEAR
nn [service name]
MULTIFUNCTION DISPLAY
SAVE
Press SAVE to Clear the storage slot.
Press EDIT in conjunction with rotating the
SELECT control to access a storage slot.
Action
Display page 4 of the preset menu (#2).
Select the required preset Service.
Press SAVE.
CONFIRM the selection.
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
service name is the stored service preset.
SELECT
4/4â
LEFT RIGHT
Result
This menu allows the currently selected preset to be cleared
from the store.
Use EDIT and SELECT to step through the stored presets.
Confirmation is required before the selection is cleared.
This clears the Service from the store and inserts the legend
[EMPTY] against the store number.
Press EDIT in
conjunction with rotating
the SELECT control to
access a storage slot.
ST.TM.E9200.8