Configuring Alteia For Use With Director; Getting Started; Do Not; Using The Alteia In The Over-Air Mode - TANDBERG Alteia Instruction Manual

D.1

Configuring Alteia for use with Director

D.1.1

Getting Started

You must have VideoGuard CA, a Director smart card and be tuned to a
Director stream.
Insert the Director smart card before tuning to the service.
Check that the unit has VideoGuard installed (Menu #13, page 8).
Set the Receiver to OVER-AIR mode (Menu #13, page 1). The REMOTE
CONTROL LED should be lit.
Check that the unit is authorised for de-scrambling the selected service
(Menu #10, page 1 SERVICE STATUS should read VGUARD AUTHORIZED.)
NOTES...
1. The CA system is unrecognised if the service is shown as CLEAR (that is, unscrambled).
2. In OVER-AIR mode, menu items can not be edited. The Receiver should be moved to LOCAL
control for editing.
D.1.2

DO NOT...

Repeatedly insert and remove the Director smart card.
D.1.3

Using the Alteia in the Over-air Mode

This section describes the behaviour of the Alteia when it is controlled
over-air using the Receiver Control part of the Director PC GUI.
It is assumed that the Receiver is entitled to receive Director commands.
Consult the Director Control PC GUI manual for more information.
The following commands are supported:
·
Display On-screen Display (OSD) Messages
·
Store Carrier Data
·
Set Power-up Channel
·
Force Carrier Retune
·
Force Service Selection
·
Set Emergency Channel
·
Set Relays
·
Set Default Language
·
Local Lockout
·
Abort NCP Command
·
Fingerprinting Overt/Covert
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
Using the Alteia [plus] with the Director System
Page D-3