Table of Contents
Advertisement
2.3.3
Installing Cables - Safety
Power supply cables should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them. Pay particular
attention to cables at plugs, convenience receptacles, and the point where
they exit from the appliance.
Do not run ac power cables in the same duct as signal leads. Do not move
or install equipment whilst it is still attached to the mains supply. Ensure
safety and ESD precautions are observed whilst inter-connecting
equipment.
2.3.4
Outdoor Antenna (Receivers Only)
Lightning Protection
IF THE RECEIVER HAS BEEN SUBJECT TO A LIGHTNING STRIKE OR POWER SURGE WHICH
HAS STOPPED IT WORKING, DISCONNECT THE POWER IMMEDIATELY. DO NOT REAPPLY
POWER UNTIL IT HAS BEEN CHECKED FOR SAFETY. IF IN DOUBT, CONTACT TANDBERG
Where appropriate, ensure this product has an adequate level of lightning
protection. Alternatively, during a lightning storm or when it is left
unattended and unused for long periods of time, unplug it from the supply
outlet and disconnect the antenna or cable system. This will prevent
damage to the product due to lightning and power line surges.
NOTE...
Terrestrial Receivers (M2/PTR[E]) are fitted with a 20 dB RF input attenuator.
Power Lines
An outside antenna system should not be located in the vicinity of
overhead power lines or other electric light or power circuits, or where it
can fall into such power lines or circuits.
WHEN INSTALLING AN OUTSIDE ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO
AVOID TOUCHING POWER LINES OR CIRCUITS AS CONTACT WITH THEM MAY BE FATAL.
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
WARNING...
TELEVISION CUSTOMER SERVICES.
WARNING...
Installing the Equipment
Page 2-5
Advertisement
Chapters
Table of Contents
