Menus
C.16.3 Director System
Using the PIN Number
The PIN number is required so that the LOCAL LOCKOUT command
(sent over-air) can be temporarily overridden.
If the password is correct, pressing SAVE
changes the CONTROL MODE to
Moving back into the Over-Air mode
automatically puts the unit into LOCAL
Figure C.7: Using the PIN Number (Director Systems)
Setting the PIN Number
If the password is valid, pressing SAVE
changes the PIN and the SET PIN display is
#13 SYSTEM
PIN INVALID
* * * *
Figure C.8: Setting the PIN Number (Director Systems)
Page C-38
#13 SYSTEM
CONTROL MODE
LOCAL LOCKOUT
Attempting to change the control mode
from LOCAL LOCKOUT displays a
#13 SYSTEM
PLEASE ENTER PIN
#13 SYSTEM
CONTROL MODE
LOCAL ONLY
#13 SYSTEM
CONTROL MODE
LOCAL LOCKOUT
#13 SYSTEM
CONTROL MODE
LOCAL LOCKOUT
32/234
#13 SYSTEM
SET PIN
* * * *
#13 SYSTEM
32/234
PLEASE ENTER OLD PIN
* * * *
32/234
#13 SYSTEM
SET PIN
* * * *
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
1/234
1/234
* * * *
If the password is invalid, pressing SAVE
displays a message and, after 3 seconds,
1/234
#13 SYSTEM
PIN INVALID
This state is temporary (as a LOCAL LOCKOUT can be
permanently removed only by an Over-Air command).
1/234
1/234
Use this screen to set the PIN as
required.
This acts as a password control.
If the password is invalid, pressing SAVE displays a message and, after
3 seconds, the SET PIN display is entered with the old PIN still valid.
32/234
The factory default is 0000
1/234
ST.TM.E9200.8