Power-Up Operating Modes - TANDBERG Alteia Instruction Manual

Operating the Equipment Locally
3.1.4

Power-up Operating Modes

If the EDIT button is pressed (and held until the name ALTEIA appears in
the display) as power is applied, the Alteia enters the Front Panel test
mode (see Chapter 6, Preventive Maintenance and Fault-finding).
The Front Panel
software can be
updated following a
software download.
The LEFT button
LED flashes during
the re-boot process
The default Service is
set in the Preset Menu
(Menu #2 page 7)
If no default has been
entered, the service
will then require
manual setting
Figure 3.1: Power-up Operating Mode
Page 3-4
The Welcome page is displayed
and The LEFT button LED is lit
during the power up sequence
Yes
Secondary
Flash code
is loaded
Yes
Front Panel
code updated
if different to the
installed version
Local
LOCAL
CONTROL
NCP Command
LOCAL
LOCKOUT
Enter PIN
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
Power-up
Is the
Yes
EDIT button
held in?
Front Panel
Test Mode*
No
(see Chapter 6)
Is the
RIGHT button
held in?
No
Has
new Front Panel
software been
received?
No
Alteia Initialisation
Acquire Default Service
Show STATUS menu (#1)
What was
Remote
Control Mode at
Power Off?
Over-Air
(NCP)
REMOTE
CONTROL
Only available if
TANDBERG
VideoGuard is
DIRECTOR:
installed and a valid
OVER-AIR
Smart card inserted
CONTROL
*Test Mode available on
version 2.2 onward
TANDBERG Director,
Over Air only:
This action allows the inactive
code held in FLASH to be used.
Note that when used, this then
becomes the active code.
ST.TM.E9200.8