Input Connectors, By Alteia Model; Pdu Decoder - TANDBERG Alteia Instruction Manual

2.7.2

Input Connectors, By Alteia Model

PDU Decoder

Models Covered
Table 2.4 applies to models M2/PDU/942 and M2/PDU/942B only.
ASI Fibre-optic Input
This port is used to provide an ASI compliant
fibre-optic connection at a fixed line
transmission rate of 270 Mbit/s.
This input is activated through the Decoder Input menu #4. The
specification for this connector is given in Table B.12.
NOTE...
The Class 1 LASER warning is as defined in paragraph 5.2 of EN 60825-1 1994.
Table 2.4: DVB-ASI Fibre-optic Connector
Item
Connector type
Connector designation
Fibre optic cable
Cable attenuation
Cable length
ASI Copper Input
Provides a DVB compliant copper connection on
the M2/PDU/942[B][C][D] models.
This input is activated through the Decoder Input
menu #4. The specification for this connector is given
in Table B.13.
The input is byte-mode only for M2/PDU/942[B]. It is byte-mode and single
packet burst mode for M2/PDU/942C[D].
Table 2.5: DVB-ASI Copper Connector
Item
Connector type
Connector designation
Cable specification
Pin
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
LASER: CLASS I LASER PRODUCT
DO NOT LOOK INTO THE APERTURE.
LOOKING INTO THE APERTURE COULD CAUSE DISCOMFORT TO YOUR EYE.
Specification
SC type
ASI-O
Multimode 65.2/125 mm
1.5 dB/km at 1300 nm maximum
£2.66 km
Specification
BNC, Female 75 W
ASI-C
capable of transmitting a maximum frequency of 850 MHz
Centre Signal
Shield Ground/Chassis
WARNING...
Installing the Equipment
Page 2-11