Ptre Digital Eng Receiver; Frame Sync Connector (Alteia Plus Only) - TANDBERG Alteia Instruction Manual

Installing the Equipment

PTRE Digital ENG Receiver

IF Input
Table 2.11 applies to models M2/PTRE/942, M2/PTRE/948C and
M2/PTRE/948CVL
A BNC socket provides a connection for the IF output
of a suitable SHF radio Receiver to the IF INPUT
connector, either directly or via a suitable attenuator
giving adequate consideration to lightning and surge
protection - see Section 2.3.4, Outdoor Antenna.
In most cases an attenuator is not required. One
should be used if the wanted input level or the
adjacent channel PAL signals are greater than
20 dBm.
This input is activated through the Digital ENG Input menu #4. The
specification for this connector is given in Table B.22.
Table 2.11: IF Input Connector (PTRE Digital ENG)
Item
Connector type
Connector designation
Pin:
Impedance

Frame Sync Connector (Alteia plus Only)

This is a purchasable option (M2/PRO/SYNC) for Alteia plus models.
Frame sync is an input that will accept a video signal containing burst and
sync at either 525 or 625 line standard (the line standard must match that
of the video signal being decoded). The decoded video in the Alteia plus is
locked to a local video source at a head-end or other installation where
multiple units are working together. It ensures that a number of IRDs are
running at the same frame rate since they would all be locked to a
common reference. The Frame Sync is activated through the Video menu
#6 if the option has been purchased.
The specification for this connector is given in Table B.23.
Figure 2.8: FRAME SYNC Connector, Location
Page 2-16
Specification
BNC Female
IF INPUT
Centre RF Input
Shield Ground/Chassis
75 W (nominal)
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
IF INPUT
FRAME SYNC
(OPTION)
ST.TM.E9200.8