Additional Menus For Alteia Plus Models - TANDBERG Alteia Instruction Manual

C.9.2

Additional Menus for Alteia plus Models

There are a number of menus that are applicable to Alteia plus models.
Table C.15: Video Menu (#6) Pages for Alteia plus Models
Pages Display
10 #6 VIDEO
selectable EDH
DISABLED
11 #6 VIDEO
editable EMBEDDED AUDIO
CHANNEL 1
12 #6 VIDEO
TEST PATTERN
selectable
8
13 #6 VIDEO
selectable FRAME SYNC
ENABLED
14 #6 VIDEO
editable FRAME SYNC 625
OFFSET +13824
15 #6 VIDEO
editable FRAME SYNC 525
OFFSET +13728
16 #6 VIDEO
editable VIDEO OUTPUT SHAPING
CVBS – 704 PIXELS
Table C.16: Video Test Patterns (Menu #6 Page 12)
Test
Disabled
1
2
3
4
5
6
7
8
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
Description
310/164 This page allows the user to enable or disable the pass-through of
Error Detection Hierarchy (EDH) data.
311/164 This page allows the user to enable and set up the decoding
DID of audio signals embedded in the video signal.
2FF Data ID can be edited by using the LEFT and RIGHT buttons
to select a hexadecimal digit and the SELECT control to
change its value.
312/164
This menu allows the user to select a test pattern and have it
STD available at the analogue video output. Pressing the RIGHT
625 button allows the line standard to be selected; pressing the
LEFT button allows the test patterns to be selected. The
choice made is enabled when the SAVE button is
pressed.
313/164 This page allows the user to enable the use of the Frame
Sync input (using the F SYNC connector at the rear of the
NOT LOCKED unit). Only available if Frame Sync Option is purchased.
314/164 This page allows the user to set the offset delay of the frame sync
signal (in units of 37ns,
Option is purchased.
315/16
This page allows the user to set the offset delay of the frame sync
+ signal (in units of 37ns,
Option is purchased.
316/16
This page allows shaping of the output video, depending on the
encoding source.
Description
Normal video
Pulse and Bar, 20T Magenta Pulse and Luminance Staircase
Multiburst
Pulse and Bar and Chrominance Staircase
Chrominance Step and Burst
Flat Field Red
Luminance Ramp
Component Ramps (YC C
R B
Colour Bars
1 / MHz). Only available if Frame Sync
27
/ MHz). Only available if Frame Sync
1
27
ramps)
Menus
Options
DISABLED
ENABLED
NONE DID
BOTH (Data ID)
CHANNEL 1
0x000 to
CHANNEL 2
0x7FF
Test Pattern: (Line) STD:
DISABLED, 625
525
1 – 8 see
Table C.16
DISABLED
ENABLED
+13824 to -13824
+13728 to - 13728
CVBS – 704 PIXELS
SDI – 720 PIXELS
Page C-23