Digital Audio; Audio Monitor; Supported Audio Modes - TANDBERG Alteia Instruction Manual

Digital Audio

Table B.29 applies to M2/Pxx/94x Models.
Two audio connectors are provided for two digital stereo or dual-channel
audio outputs conveying Dolby Digital 5.1, Dolby Digital AC-3 or Linear
PCM.
Table B.29: Digital Audio Output Connector
Item
Safety status
Output format
Output level
Nominal output impedance
Load impedance

Audio Monitor

Table B.30: Audio Monitor Connector
Item
Safety status
Output level
NOTE...
Audio Monitor performance characteristics are different to those measured at the rear panel connectors.

Supported Audio Modes

Table B.31 shows the supported audio output modes.
Table B.31: Supported Audio Output Modes
Audio Mode
Single channel
Dual channel mono
Joint stereo (Intensity stereo)
Stereo
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
Specification
SELV
AES/EBU in IEC958 Analogue, Compressed, Professional or Consumer (selectable).
See Table C-19 on Page C-25 for further information.
5 Volts nominal, coded signal level –12 dB FS nominal.
50 W
110 W
Specification
SELV
0 dBm nominal
Description
A single channel is output to both XLR connectors.
Two mono signals are carried in the transport stream as a single PES - both are decoded
and output on the appropriate connector. One mono source can be output to both
connectors.
Stereo pair is coded taking advantage of the stereo nature of the channels.
Stereo pair is coded as two mono signals - the signals are output to the two XLR
connectors.
Technical Specification
Page B-17