Audio #1, #2 L&R (Front Panel); Control Connectors; Rs-422 Data - TANDBERG Alteia Instruction Manual

Audio #1, #2 L&R (Front Panel)
This is a ¼" jack socket, which provides an analogue
audio monitoring output. The format of this output is
the same as the analogue audio output at the rear of
the unit.
The specification for this connector is given in
Table B.30.
Table 2.19: Audio Monitor, Front Panel
Item
Connector type
Output format
Connector designation
Connections:
Impedance
2.7.4

Control Connectors

RS-422 Data

The connector provides a synchronous serial
communications interface for the reception
of high-speed synchronous data.
The status of the data output on this connector
is given in the Data menu #11.
The specification for this connector is given in
Table B.33.
NOTE...
The RS-422 High-speed Synchronous Data output is available on all models except M2/PSR/932C
and those without a suffix letter.
Pins 2 and 9 of the RS-422 15-way D-type are used for field upgrade. Connection to these pins by
Always ensure that RS-422 cables are connected according to the pin-outs described in Table 2.20.
Table 2.20: RS-422 High-speed Data Connector
Item
Connector type
Connector designation
Pin-outs
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
ST.TM.E9200.8
Specification
¼" jack socket
Same as the rear panel, analogue audio output (chosen by menu).
AUDIO #1 (#2) L&R
Tip Audio Left output
Ring Audio Right output
Collar Screen/Ground (chassis)
600 W
equipment not supplied by field service personnel could result in damage to the unit.
Specification
15-way D-type, Female
RS-422 DATA
Pin 1 ¾ Ground
Pin 4 ¾ DATA (+)
Pin 6 ¾ CLOCK (+)
CAUTION...
Pin 8 ¾ GROUND
Pin 11 ¾ DATA (-)
Pin 13 ¾ CLOCK (-)
Installing the Equipment
AUDIO #1 (#2)
L&R
8 1
15 9
RS-422 DATA
Page 2-21