TANDBERG Alteia Instruction Manual page 160

Menus
Page Display
6 #13 SYSTEM
SELF TEST REPORT
NO FAULTS REPORTED
7 #13 SYSTEM
MODEL
PSR / 940
8 #13 SYSTEM
MODEL OPTIONS
ASI / DAC3/ VG05 / RAS
9 #13 SYSTEM
DEMUX PART NUMBER
Xnnnn
10 #13 SYSTEM
DEMUX SERIAL NUMBER
XXXXXXXX
11 #13 SYSTEM
DEMUX APP CODE VER
XXXXXXXXXXX
12 #13 SYSTEM
DEMUX CORE CODE VER
XX.XX
13 #13 SYSTEM
DEMUX DRV CODE VER
XX.XX
14 #13 SYSTEM
DEMUX DIAG CODE VER
XX.XX
15 #13 SYSTEM
OUTPUT PART NUMBER
S8715-1
16 #13 SYSTEM
U / P PART NUMBER
XXXXXXXX
17 #13 SYSTEM
U / P CODE VERSION
XXXXXXX
18 #13 SYSTEM
I / P PART NUMBER
S8675-1
19 #13 SYSTEM
I / P CODE VERSION
NOT APPLICABLE
20 #13 SYSTEM
RESTORE SYSTEM
DEFAULTS
21 #13 SYSTEM
editable RESET LOCKOUT PIN
* * * * * * * * * * * * *
22 #13 SYSTEM
selectable SMALL RBUFF MODE
DISABLE
23 #13 SYSTEM
selectable 525 VIDEO START
LINE 23
Page C-36
Description
36/234
The displays the result of the power-up self-test.
37/234 Displays the Model number of the unit.
38/234
Displays any installed options.
39/234
310/234
311/234
312/234
This is the
version on the
manual cover.
313/234 Removed on
version 2.2
and later.
314/234 Removed on
version 2.2
and later.
315/234 This allows the output card to be identified.
316/234 This allows the microprocessor card to be identified.
317/234
This allows the code version of the microprocessor card to be
identified.
318/234 This allows the input card to be identified.
319/234
This allows the code version of the input card to be identified.
320/234 This menu allows the factory defaults to be restored. It does not reset
the Local Override PIN or Service Presets. See Annex F for Factory
Defaults.
321/234 Allows the 4-digit PIN used to override the LOCAL LOCKOUT mode to
be reset to a known value (0000). This is used in emergencies only.
322/234 This menu allows the receiver's small rate buffer mode to be enabled
or disabled.
When decoding a signal generated by one of the M2/ENC/E5xxx
Encoders or any other manufacturers Encoder, the small rate buffer
should be disabled.
For any earlier Encoder, the small rate buffer should be enabled.
323/23 This allows the start line for 525-line standard to be specified.
Instruction Manual: Alteia and Alteia plus Professional Receivers and Decoders
This set of menus allows
the make up of the
Demultiplexer card to be identified.
Options
13-digit PIN
ENABLE,
DISABLE (Default)
22, 23
ST.TM.E9200.8