Hioki Memory HiLogger LR8401-20 Instruction Manual page 265

Warning Messages
Appears just once when an error occurs. Disappears within a few seconds. Also
disappears when any key is pressed.
Message
101
Invalid key.
102
Cannot start measurement.
103
Cannot change while measuring.
201
Exceeding the setting range.
204
Measurement range changed.
Recording time has been changed
230
due to memory limit.
231
Pre-Trigger span changed.
Recording and Pre-Trigger spans
232
changed due to waveform memo-
ry limit.
233
Trigger or alarm changed.
Burn Out (broken-wir) detection
234
changed.
Cannot change Burn Out (broken-
235
wire) detection.
236
File partition period was changed.
237
File partition time was changed.
CSV auto save has been set.Un-
238 able to set the specified record in-
terval.
Appendix 2 Error Messages and Remedial Actions
Remedial Action
The pressed key is disabled due to measuring or
other operation. Press the key again after the cur-
rent operation finishes.
The START key is disabled when the current screen
is displayed. Switch to the Waveform/Numerical
screen before starting measurement.
Press STOP to stop measuring before changing the
setting.
The entered numerical value is out of the valid
range. Enter a valid value.
When [Type]-[Up/Lwr]
ment range is automatically changed to match the
upper and lower limits.
Increasing the number of measurement channels
has decreased Internal memory waveform
data capacity.
Increasing the recording interval or length requires
reducing pre-trigger recording time.
Increasing the recording interval requires reducing
recording length and pre-trigger recording time.
The setting ranges for count integration and revolu-
tions have been changed.
Burn-out detection is not available with the current
settings. To enable burn-out detection, select a long-
er recording interval or reduce the number of chan-
nels used.
"About the Recording Interval" (p .54)
See:
The setting is not available due to the combination of
the number of channels used and the recording in-
terval. To enable burn-out detection, select a longer
recording interval, or reduce the number of channels
used.
"About the Recording Interval" (p .54)
See:
The segment time span has been changed in re-
sponse to changing the recording interval.
The segment time span has been changed in re-
sponse to changing the recording interval.
The recording intervals available for CSV auto sav-
ing are limited. Select a longer recording interval.
"Automatic Saving (Waveform Data and
See:
Numerical Calculation Results)" (p .127) ∗2
is selected, the measure-
3
A