Trigger Setting Examples - Hioki Memory HiLogger LR8401-20 Instruction Manual

5.6 Trigger Setting Examples

Following are examples of typical trigger settings.
Acquire data from when you press
Acquire data for one minute after each time you press
Acquire data at one-minute intervals for sixty minutes after you press
When the temperature measured on CH1 exceeds 500°C, acquire data until you press
STOP
.
Acquire data from when you press
500°C.
Acquire data from when the temperature measured on CH1 exceeds 500°C until it drops
below 300°C.
Acquire data whenever the temperature measured on CH1 exceeds 500°C, until it drops
below 300°C.
Acquire data for only one minute from when the temperature measured on CH1 exceeds
500°C.
Acquire data for one minute before and after the time when the temperature measured on
CH1 exceeds 500°C.
Acquire data from 9:00 to 17:00 on 6/17/2008.
Starting at 9:00 on 6/17/2008, acquire data for 24 hours/day, for one month.
Starting on 6/17/2008, acquire data continuously from 9:00 to 17:00 daily for one month.
Starting on 6/17/2008, acquire data for one hour at 9:00, 15:00, 21:00, and 3:00 daily for one
month.
Intended Measurement Objective
START
until you press
START
START
until the temperature measured on CH1 exceeds
5.6 Trigger Setting Examples
STOP
START
121
Ref. No.
(next table)
No.1
No.2
No.3
3
No.4
No.5
5
No.6
No.7
No.8
No.9
No.10
No.11
No.12
No.13