Hioki Memory HiLogger LR8401-20 Instruction Manual page 268

6
A
Appendix 2 Error Messages and Remedial Actions
Message
506
File system error (incorrect device).
507
File system error (file protected).
File system error (failed to recog-
508
nize the format).
File system error (limit of the num-
509
ber of files).
510
File system error (same name file).
511
File system error (system busy).
File system error (too long path
512
name).
513 File system error (no file).
514
File system error (mode error).
515
File system error (invalid file handle).
516
File system error (file offset error).
File system error (not enough ca-
517
pacity).
File system error (invalid file
518
name).
519
File system error (directory error).
520
File system error (invalid file type).
521
File system error (file rename error).
File system error (internal parame-
522
ter error).
523
File system error (block size error).
524
File system error (semaphore error).
File system error (not supported
525
action).
603
Communication error.
620
Bad MAC address.
621
Bad IP address.
Remedial Action
Turn the HiLogger off and back on. If the fault per-
sists, perform system reset (p. 153).
The requested write process (including deletion)
could not be performed because the file attribute is
read-only. Use a PC to cancel the read-only setting.
The removable storage could not be recognized.
Reformat the removable storage on a PC. If the error
persists, try a different removable storage.
If this error occurs while using a good removable
storage, the HiLogger may be damaged, in which
case contact your dealer or Hioki representative.
The number of files to be processed exceeds the limit,
so processing cannot be performed. Delete files to in-
crease free space, or try another removable storage.
An attempt was made to create a file with the same
name as an existing file. Change the name of the file
to be created (p. 139).
Processing could not be performed because files
are in use by another executing process. Wait for the
current process to finish. If there is no other execut-
ing process, turn the HiLogger off and back on.
The specified path name is too long. Re-enter the
name of a removable storage folder from the PC.
Turn the HiLogger off and back on. If the fault per-
sists, perform system reset (p. 153).
Insufficient free space is available on the removable
storage for the process to execute. Delete files to in-
crease free space, or try another removable storage.
The file name contains an invalid character. Rename
the file (p. 139).
Turn the HiLogger off and back on. If the fault per-
sists, perform system reset (p. 153).
Check communication settings.
The HiLogger's MAC address has been improperly
altered. Please contact Hioki.
Check the IP address setting.