Setting The Address - Simplex 4100ES Installation Manual

22.6.3 EPS IDNet 2 Configuration

22.6.3.1 Setting the Address

The DIP Switch SW1 is used to set the IDNet 2 address as identified in the Panel Programmer job (see the section on Programming for
more information). From left to right, these switches are designated as SW1-1 through SW1-8. The function of these switches is as follows:
• SW1-1. This switch sets the baud rate for the internal 4100 communications line running between the card and the 4100 CPU. Set
this switch to ON.
• SW1-2 through SW1-8. These switches set the card's address within the FACU. Refer to Figure 112 for a complete list of the switch
settings for all of the possible card addresses.
You must set these switches to the value assigned to the card by the Panel Programmer.
page 186
Figure 111: DIP Switch SW1
4100ES Fire Alarm System Installation Guide
574-848 Rev. BQ