Tic Configuration; Mounting Instructions - Simplex 4100ES Installation Manual

Name
Basic Transponder Interface Card
Local Transponder Interface Card
6.3 Configuring Cards
The TIC and all other cards to be mounted in the transponder cabinet and attached expansion bays must be configured to operate
correctly in the system via their DIP switch and jumper ports. The CPU motherboard may have to be configured as well.
6.3.1

TIC Configuration

The TIC must be assigned a device address via DIP switch SW1. Refer to
switch table.
6.3.2 Configuring Other Cards
Refer to the appropriate publication to configure other cards that are located in the transponder cabinet and attached expansion bays.
6.4 TIC/Riser Mounting
All TICs and audio riser cards are mounted like any 4 x 5 card. This section describes the TIC/audio riser card mounting procedure, which is
identical to that of other 4 x 5 cards.
6.4.1

Mounting Instructions

Use the following instructions and Figure 35 to mount 4 x 5 cards in an expansion cabinet.
Important:
• The TIC must be mounted in the upper left position of the bay.
• The audio riser card must be mounted directly below the TIC.
1. Screw two standoffs and washers to the appropriate holes in the back of the cabinet. These holes must line up with the screw
holes in the card. See Figure 35.
2. Plug the card into the top left PDI connector (P8).
3. Secure the top of the card to the standoffs with two #6 torx screws and washers.
page 68
Table 9: Replacement boards
Legacy Card
0566-093
0566-094
Appendix A: The Device Configuration DIP Switch
4100ES Fire Alarm System Installation Guide
New Card
0566-1166
0566-1167
for the address
574-848 Rev. BQ