Simplex 4100ES Installation Manual page 62

5.13.2 Installing and Removing Batteries in a Multi-Bay Cabinet
To install the batteries:
1. Remove the batteries from the packaging and inspect them for any damage.
2. Place the batteries at the bottom of the cabinet, center them and gently push them against the back wall.
3. Once the batteries are in place remove the terminal protectors from the batteries.
4. Connect the batteries to the panel using the battery harness:
- Connect the positive terminal of the left battery to the positive battery input on the panel using the red cable.
- Connect the negative terminal of the right battery to the negative battery input on the panel using the black cable.
- Use the white jumper cable to connect the two remaining battery terminals, joining the two batteries.
- If your system is configured to draw more than 19 A the included spade connectors cannot be used. Cut the connectors off and
strip back the insulation. Using the proper connector for your battery, crimp the now exposed wiring to your new connector.
5. Power up the panel following the instructions in
To remove the batteries:
1. Power Down the Panel following the instructions in
2. Remove the harness from the batteries.
3. Fit the battery terminals with terminal protectors.
4. Remove the batteries from the cabinet.
Dispose of the old batteries properly.
page 60
Step 10. System Power Up and Power Down
Step 10. System Power Up and Power Down
4100ES Fire Alarm System Installation Guide
Procedures.
Procedures.
574-848 Rev. BQ