Simplex 4100ES Installation Manual page 215

23.3.1 Installing the System Electronics Bays
The system electronics bays for each back box are mounted on two rails. These rails are secured inside a cardboard shipping container
when shipped from the factory.
Perform the following procedure to install the system electronics bays.
1. Remove everything from the electronics shipping container. To remove the 635-852 Battery Terminal Block, unscrew the two 8-2
shipping screws that secure it to the container as shown in Figure 137. Save the two lockwashers and nuts.
2. Remove the 10-32 shipping studs that secure the vertical rails to the shipping container as shown in Figure 137.
3. Using the hardware provided (as referenced in Table 46), insert a mounting screw in both the top right and top left track support
holes in the back box as shown in Figure 138.
page 213
Figure 137: Removing the Shipping Studs
4100ES Fire Alarm System Installation Guide
574-848 Rev. BQ