Ethernet Service Port And Serial Service Port - Simplex 4100ES Installation Manual

4100ES Fire Alarm System Installation Guide
Master Bootloader Interface Mode:
This interface should be used when the Master executable is not functioning. It downloads the Master CPU Exec firmware and the CFG.TXT
file to the CPU using the serial port.
Figure 71: Bootloader Interface
10.2

Ethernet Service Port and Serial Service Port

10.2.1 Ethernet Service Port Overview (0566-719 only)
The Ethernet service port J1 on the CPU card (0566-719) is used to connect the panel to a local PC. See Figure 72 for the port location.
Figure 72: CPU card ports
The Ethernet service port connects to the front panel Ethernet connection through a standard straight (non-crossover) Ethernet Patch
Cable. The service technician should connect his PC to the CPU card through this front panel connection with a standard straight Ethernet
cable (see ). If this connection is not available, you may plug directly into the CPU Card connector J1 to the PC with a standard straight
Ethernet cable.
Note: Depending on optional cards in your system, the CPU Ethernet port may not go directly to the front panel service port. In these
cases do not disconnect the CPU card from the option modules for use of the Ethernet service port. The optional cards will have a port for
direct connection to the front panel Ethernet service port.
page 106 574-848 Rev. BQ