Wiring With The Wired Media Card - Simplex 4100ES Installation Manual

Fire alarm system
Hide thumbs Also See for 4100ES:
Table of Contents

Advertisement

(fiber loss, connector loss, splice loss and safety margin), or the maximum distance listed, whichever is smaller.
Wavelength: Left media = Tx 1550/Rx 1310 nm. Right media = Tx 1310/Rx 1550.
4.
Link Budget: Attenuation should be measured at the following wavelengths.
5.
- Multi-mode @ 1300nm
- Single-mode @ 1310nm
7.5.9

Wiring with the Wired Media Card

Refer to the guidelines and figures in this topic to use wired media cards.
Important: TB1 on the wired media card must not be used when it is connected to the 4100-6078 NIC.
• When the 565-413 Interface Card is used with 565-516, 566-407, 566–409, or 566-793 Network Card, TB1 on the 565-413 Interface
Card cannot be used. Connection to the motherboard is required as shown.
• The shield should only be connected at one end of the line. The shield is connected to the left port.
• When wiring leaves the building, 2081-9044 Overvoltage Protectors are required. One overvoltage protector is installed where wiring
leaves the building; another is installed where wiring enters the next building.
Table 16, lists the 4100ES master motherboard connections for the wired media card.
566-227 CPU Master Motherboard
Motherboard Port for
Media Card Connected to
P5
TB1
TB1-4
TB1-5
TB1-6
TB1-7
TB1-8
Motherboard Port for
Media Card Connected to
P6
TB3
TB3-1
TB3-2
TB3-3
TB3-4
TB3-5
Figure 53, shows how two CPU motherboards with wired media network cards connect to each other in the 4100ES.
page 88
Table 16: CPU Motherboard Wired Media Connections
Wired Media Card Connection
(Left Port)
0 V
Earth ground
INV (-)
None
NONINV (+)
Wired Media Card Connection
(Right Port)
NONINV (+)
Reserved
INV (-)
Earth ground
0 V
Figure 53: Wired Media Interconnections Between 4100ES Motherboards
4100ES Fire Alarm System Installation Guide
RUI+ CPU Master Motherboard (566-938)
Motherboard Port for Media Card
Connected to P5
TB2
TB2-4
TB2-5
TB2-6
TB2-7
TB2-8
Motherboard Port for Media Card
Connected to P6
TB3
TB3-1
TB3-2
TB3-3
TB3-4
TB3-5
Wired Media Card
Connection (Left Port)
0 V
Earth ground
INV (-)
None
NONINV (+)
Wired Media Card
Connection (Right Port)
NONINV (+)
Reserved
INV (-)
Earth ground
0 V
574-848
Rev. BQ

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents